SETUP INSTRUCTIONS

Please completely read the following information before use – failure to follow these instructions may result in product damage, injury, or property damage.  BoboDirect is not liable for damage or injury caused by misuse, over-filling, over-inflation, or failure to follow these instructions. This product is recommended for ages 6 and above.  Adult supervision is required for children. Thank you for your purchase! 

Follow these steps to safely set up your inflatable punching doll.

 

SETUP & PREPARATION
Location
Always set up on a flat, smooth, indoor surface or soft grass. Keep away from walls, furniture, sharp objects, and breakables.

Filling the Base with Water (stability)
Maximum 15 liters (approx. 3.8 gallons / 80–90 % full).
STOP filling when you can still see an air gap at the top.
 WARNING: Over-filling can cause seams to burst and release water suddenly, resulting in flooding and property damage.
Sand is NOT recommended and will void warranty.

Inflating Middle & Upper Sections
Use only a manual pump or your lungs.
NEVER use a high-pressure electric compressor (e.g., car-tire pump).
Maximum safe pressure: 2.0 kPa (≈ 0.29 psi).
Inflate until firm but still has slight give when pressed. It must NOT feel drum-tight.

STOP immediately if:
Material becomes shiny and completely wrinkle-free
Seams turn white or look stretched
No give when pressed firmly
Over-inflation can cause loud bursting and possible injury. Check air pressure before every use.

Dangers of Over-inflation
Over inflation can cause loud bursting and possible injury. 
Check air pressure before every use.

 

SAFE USE
Indoor Use (recommended)
Best on carpet, gym mats, or smooth floors.
When using on hardwood floors and carpets, be completely cognizant of overfill and potential water damage to those surfaces.

Outdoor Use
Only on soft, flat grass.
 Concrete, asphalt, gravel, or patios will cause rapid wear and punctures.
Outdoor use shortens product life and is at your own risk.

Temperature Limits
Do NOT use or store above 40 °C (104 °F) — heat causes air to expand and seams to fail.
Do NOT use below 4 °C (39 °F) — cold makes PVC brittle and prone to cracking on impact.
Never leave inflated in a hot car, direct sun, or near heaters.

 

CARE & STORAGE
Cleaning
Deflate upper sections before cleaning.
Wipe with mild soap and water only.
Never use bleach, solvents, abrasives, or pressure washers.

Short-term storage (days/weeks)
Empty all water
Deflate completely
Wipe dry inside and out
Store in a cool, dry place away from sunlight

Long-term storage (e.g., winter)
Clean and completely dry (moisture causes mold)
Deflate fully and remove all water
Fold loosely along original creases
Store in a cool, dark, dry location (closet is ideal)
Protect from rodents and insects

 

IMPORTANT LEGAL NOTICES
This product is not a toy for sitting, standing, or climbing.
Use only for its intended purpose (punching/kicking while standing upright).
BoboDirect is not responsible for personal injury, property damage, or product failure resulting from improper setup, over-filling, over-inflation, temperature exposure, outdoor use on hard surfaces, or failure to follow these instructions.
All warranties are void if these instructions are not followed.